"NEW" 24rd +1 Patent Pending Follower Design for 2026



"NEW" for 2026 24rd +1 Competition Spring & Follower set for ALL 2011 FACTORY Magazines



What You Have Been Waiting for MBX ULTIMATE 24rd +1 Spring Follower Set!


Featuring
MBX "NEW" Patent Pending Follower
& Proven 11 Coil Square Bottom Spring

Capacity Listed Below for 141.25mm Magazines:

- Staccato 24rd +1
- Checkmate 24rd +1
- Springfield 24rd +1
- SV Infinity 24rd +1
- Atlas 24rd +1
- Kimber 24rd +1
- BUL 24rd +1




To Achieve 24rd +1 with our NEW 2026 Design


*Note: Factory style tubes with the “NEW” MBX Spring and Follower Set that extend to141.25mm allows for our combination using non lock back NEW Competition Follower to hold 24rd +1


Important Technology Information ~ Read to avoid damage to your new spring follower

New "Patent Pending" Limited Optics 9mm Competition follower

MBX has developed a New follower design for all other factor style tubes Springfield ,staccato , SV Infinity , checkmate, Atlas. We use our same proven square bottom 11 coil competition spring that has performed flawless with millions of rounds. The new follower was developed and tested over 2 1/2 years as the follower need to help factor extended141.25 mm tubes to hold 24 rds and present the Bullet fast while keeping the bullet nose up in order to assure feeding from the first shot until the last round.

FYI


The follower and spring are designed to sit lower in the magazine than factory follower this is by design to stop any slide contact when the last round is fired because the competition follower will not contact the slide stop obviously the follower needs to sit lower. BE SURE TO FULLY LOAD MAGAZINE 3-4 times when New to Set the spring to its working length and avoid the follower getting hit by the slide damaging the spring and shoving the follower into the feed ramp. NOT A GOOD START!

Reload your own ammo!

Ammo recommend specs for reliability 2011

FYI Do not run short OAL or wide Crimp this is a performance killer Flat Nose projectile is not recommended Round nose is King

OAL 1.155 to 1.165

Crimp .372 -.374 max

Be sure all primers are seating correctly in pockets

I like to use the Lee crimp/seating die with carbide ring as it will straighten and projectile then crimp works great.


VERY IMPORTANT INSTALLATION VIDEO




"NEW" FROM MBX DUTY & CARRY LOCK BACK SPRING FOLLOWER SET FOR FACTORY TUBES


HOLD 21 RDS FOR 140MM & 18RDS FOR 126MM FOR:

- SPRINGFIELD FACTORY TUBES
- SVI/INFINITY FACTORY TUBES
- CHECKMATE/ATLAS FACTORY TUBES
- BUL/ARMSCOR/PARA FACTORY TUBES






New MBX Injection Follower with New Overpowered Wolff Spring insures Reliability, Performance, and added Capacity you can trust.